TheHighlander wrote:OK, so, the 60cm abdomen works with the legs, hips and waist piece. But the 50cm chest piece is too snug. The smaller diameter of the 50cm chest piece makes it fit too tightly.
You can probably trim a chunk off of the 60cm abdomen piece and get it to fit. I just didn't want to cut the one I have.
DD2 bust works well.
OK, now, how does the internal skeleton of the 50 compare against the 60 in terms of length?
The length (whole torso) is pretty good.
Since you would have to trim some of the material off the top of the 60 abdomen anyway for the 50cm skeleton, could you also provide a 'v' shaped cut on either side to allow the top of the abdomen to pinch in ever so slightly to allow the 50cm bust to fit without pinching the back as you show?
I mean I can live with using a DD/DD2 bust vinyl on it, but if I'm going to have to trim the top of the abdomen anyway, is there any corrective surgery that I could do to allow the original 50cm large bust to fit, even if it's snug?
The hang up appears to be the "breast bone" in the 50cm skeleton. You would need to trim the vinyl to go underneath it.
I must say, I really like the way that 60cm abdomen matches up with the 50cm legs. Definitely an improvement over the original abdomen there.
Another possibility would be to stalk the Yamato site for one of their sales and buy a Type B abdomen. It's about as wide as the 60cm abdomen and is the required (smaller) diameter on top.
Here's the 50cm large bust on top of the Type B abdomen.