Dollieh Sanctuary

My Volkbitsu hybrid girl kept losing her pelvis piece, no matter what kind of glue I used to hold it together... (I sawed the Obitsu pelvis piece in half to get the Obitsu pelvis piece to fit with the Volks legs.)

So this time I had to work on her torso to get the Volks butt to fit instead... It comes in two pieces and is held together with screws, but the differences in how the Volks body and Obitsu body are put together made it a challenge... basically, I had to remove about 1/4"-1/2" of plastic from the bottom of her waist to make the Volks butt fit with the Obitsu torso.

Finished product:


Poor Nova, relxing after her surgery:

Good job! That had to be hard. XP

I love this hobby! This is awesome!

FOR SCIENCE! Hehehehe....

Thanks, guys >_<

I'm glad you like her.

Nice work! Don't think i could sit there and do that.

catshem wrote:Nice work! Don't think i could sit there and do that.

Well, after a lot of chipping with the x-acto knife, I finally figured out that I wouldn't be able to make the waist narrow enough to fit the butt piece over it, and went out on the deck with the hack saw and sawed the bottom part of her waist off...

Then I had to x-acto knife the edges to get them the right shape, sand a little to take off the rough edges, and then I could finally put her back together...